Euclid Euco 700 is a high-quality epoxy joint filler, known for its reliable adhesion and versatility, making it a valuable asset in construction and repair applications. Supports joint edges and reduces spalling of the edges caused by wheel traffic.
EUCO 700 is a two component, 100 percent solids, semi rigid epoxy joint filler designed for control and construction joints in industrial concrete floors. It supports joint edges, improves load transfer, and reduces spalling caused by hard wheel traffic. EUCO 700 is formulated to comply with ACI 302 recommendations for epoxy joint fillers and is intended for interior industrial and commercial floor applications.
| Mix Ratio | 1:1 by volume |
| Pot Life at 75°F | 15 minutes |
| Tack Free Time | 12 hours |
| Compressive Strength (ASTM D695, 72 hours) | 3000 psi (20.7 MPa) |
| Tensile Strength (ASTM D638, 7 days) | 690 psi (4.6 MPa) |
| Elongation (ASTM D638, 7 days) | 55 percent |
| Water Absorption (ASTM D570, 72 hours) | 1.1 percent |
| Hardness | Shore D 55 |
| Traffic Opening | 24 hours at 70°F and 50 percent RH |
| Packaging | 2 gallon unit yielding 463 cubic inches |
| Shelf Life | 1 year in original unopened containers |
Does EUCO 700 require a primer?
No. EUCO 700 does not require a primer when joints are properly cleaned and prepared.
Can backer rod be used to reduce material volume?
No. Backer rod, sand, or filler material should not be used. Joints must be filled full depth for proper load transfer.
When should joints be filled?
In accordance with ACI 302 recommendations, joints should be filled as late as possible to allow for slab shrinkage.
Is EUCO 700 UV stable?
No. Product may discolor under strong ultraviolet exposure. It is intended for interior applications.
Can EUCO 700 be used as an expansion joint sealant?
No. It is not designed for expansion joints.
Please complete your information below to login.