• Order by Phone
  • Customer Service
  • Technical Support
Need Expedited Shipping? Please Call Customer Service
My Cart

Metzger McGuire Spal-Pro Stabilizer Foam 1500ml

Orders Before 3:00 PM Ship Same Day

Availability: Out of stock

$45.48

Shipping Information: Orders over $100 ship free


QUICK OVERVIEW

Metzger McGuire Spal-Pro Stabilizer Foam 1500ml Cartridge MMSPEXPC-1500-6

Datasheet (PDF) || SDS (PDF)

Metzger McGuire Spal-Pro Stabilizer Foam 1500ml Cartridge MMSPEXPC-1500-6.Spal-Pro Stabilizer is a 100% solids, two component semi-rigid polyurea polymer intended for use in underslab stabilization of deflecting/rocking concrete floor panels. Spal-Pro Stabilizer allows for return to service in 60 minutes or less.

Metzger McGuire Spal-Pro Stabilizer is used to correct conditions where slabs deflect and/or rock when subjected to material handling vehicle loads. This condition is usually the result of slab curl or various below grade deficiencies/voids. Once pressure injected into the voids beneath the slab, Spal-Pro Stabilizercures into a hard rubber-like solid pad that fully supports the slab and reduces or eliminates deflection within 30 minutes of installation. Metzger McGuire Spal-Pro Stabilizerhas an installation and service temperature range of 120 degrees to -20 degrees farenheit.

High shore hardness and compressive strength for optimum support of slabs under load.
Rapid setting, allows for early return of traffic.
Low viscosity for easier injection and better penetration into narrow voids.

Shore A Hardness: A95-100
LEED Compliant: Yes

Requires applicator gun. See product datasheet for full specifications.

Product Tags

Use spaces to separate tags. Use single quotes (') for phrases.

Name Metzger McGuire Spal-Pro Stabilizer Foam 1500ml
Description Metzger McGuire Spal-Pro Stabilizer Foam 1500ml Cartridge MMSPEXPC-1500-6.Spal-Pro Stabilizer is a 100% solids, two component semi-rigid polyurea polymer intended for use in underslab stabilization of deflecting/rocking concrete floor panels. Spal-Pro Stabilizer allows for return to service in 60 minutes or less.

Metzger McGuire Spal-Pro Stabilizer is used to correct conditions where slabs deflect and/or rock when subjected to material handling vehicle loads. This condition is usually the result of slab curl or various below grade deficiencies/voids. Once pressure injected into the voids beneath the slab, Spal-Pro Stabilizercures into a hard rubber-like solid pad that fully supports the slab and reduces or eliminates deflection within 30 minutes of installation. Metzger McGuire Spal-Pro Stabilizerhas an installation and service temperature range of 120 degrees to -20 degrees farenheit.

High shore hardness and compressive strength for optimum support of slabs under load.
Rapid setting, allows for early return of traffic.
Low viscosity for easier injection and better penetration into narrow voids.

Shore A Hardness: A95-100
LEED Compliant: Yes

Requires applicator gun. See product datasheet for full specifications.